Other

2023/12/19

Introduction to the basic knowledge of air model fans and medium pressure fans

Previously, we introduce a lot of knowledge about the fan, I believe that you a pair of it is very familiar with, we come to introduce two new fans for the gas model fan and medium pressure fan, focusing on the definition of the gas model fan, classification, and centrifugal fan relationship, as well as the principle of operation of the medium-pressure fan, performance parameters, operating precautions and maintenance, the contents of these are specifically as follows, and I hope that readers have read it can be gained.

Learn More

2023/12/19

How to choose an air model fan?

Inflatable fans can be used in: large inflatable toys, children's amusement facilities, inflatable castles, inflatable tents, inflatable arches, inflatable jumping beds, inflatable slides, inflatable rock climbing and so on.

Learn More

2023/12/19

Precautions for air modeling fans

Notes on the air model fan:1, the installation location: must be installed in the indoor not wind and rain interference place,

Learn More

2023/12/19

Talk about the air model fan some of the notes and the basis of the

What is the relationship between pneumatic fans and industrial centrifugal fans? What is the direction of its development? In addition, there are a number of other issues, these are related to this fan, and also we need to learn to understand and master, so in the next time, that little editorial nonsense, to specifically address some of its relevance to the issue of it, the content is as follows.

Learn More

2023/12/19

Precautions for air models and selection of fans

In order to take greater care of the inflatable products, please pre-lay some old carpets on the floor before you start to install the inflatable products, so as to isolate the sand or the ground from the wear and tear of the inflatable products to a greater extent.

Learn More

2023/12/19

What need to pay attention to the use of air model blower

Please do not disconnect the power after inflating and molding the air model products. Fan inlet must not have debris, so as not to get involved in causing damage to the fan. When moving the air model products, do not pull the bottom of the air model, in order to avoid adding more unnecessary wear and tear, when moving the air model products, if the air model is too heavy, can be lifted by many people together to move, or will be inside the sandbags out, and then move the product.

Learn More

< 1234 >